EXAMPLE PAGE - USER GUIDE & ENTERPRISE - Sailrite - Flipbook - Side 68
Workhorse Servo Motor Error Codes
®
ER R O R C OD E ( W IL L S HOW
O N LE D D IS PL AY )
S O LU T IO N
“E1”: Operational failure
Machine is locked. Check to see if the machine
is difficult to turn by hand with the Power Plus®
Flywheel. Remove material and attempt to operate;
if it works, material was too heavy for motor.
“E2”: Over current or under voltage
Check the power source to ensure that the motor
voltage matches the outlet voltage.
“E3”: Board cannot read the parameter
Turn the power off and on twice, and try again. If the
problem still occurs, contact Sailrite.
“E4”: Hall signal error
Replace the main fuse. To do this, turn off and
unplug the motor, remove the front external plastic
cover and replace the main fuse with one of the
extras sent with the motor. If the problem continues
to persist, please contact Sailrite®.
1. Press and release the “S” button and the LED
display will change to “P.”
2. Press the “P” button 2 times and the display will
change to “n1.”
“E5”: Needle position problem
3. Press the “S” button and the display will change
to “1.”
4. Press the “S” button again and the display will
change to “0” (disable needle positioner).
5. Press the “P” button to save the value.
6. Turn the power off and then on again to complete
the programming.
65 |
Sailrite.com
